23 Replies to “Affordable Web Design Auckland”

  1. every good instruction video i watch, I always want to meet the sack of you know what who must click "dislike". what's not to like on this video if you don't know shzt about soldering?

  2. I am using lead-free solder and a 60W (450degrees) iron. I'm cleaning the tip and using flux, but I can't manage to solder ANYTHING. The solder sticks to the iron, or the small ball that forms falls on the table. Solder WILL NOT stick to copper wires or circuit contacts. The tip of the iron doesn't even melt the solder, it takes 8-10 seconds to melt, the only way is to use the body or base of the iron tip to melt the damned solder. What the hell am I doing wrong? Is it the solder's fault, the iron's the flux's???

  3. I am using lead-free solder and a 60W (450degrees) iron. I'm cleaning the tip and using flux, but I can't manage to solder ANYTHING. The solder sticks to the iron, or the small ball that forms falls on the table. Solder WILL NOT stick to copper wires or circuit contacts. The tip of the iron doesn't even melt the solder, it takes 8-10 seconds to melt, the only way is to use the body or base of the iron tip to melt the damned solder. What the hell am I doing wrong? Is it the solder's fault, the iron's the flux's???

  4. 60 watt iron from Bangood. Solder says "Model B-1, Flux 2%, 63/32 ratio. Iron is glowing red hot inside. Still can't get the solder to melt. No flow even after holding the iron to the piece for several minutes. What am I doing wrong??

Leave a Reply

Your email address will not be published. Required fields are marked *